Giant 1-Feb Manuel d'utilisateur télécharger pdf (Page 7)

Installing and Starting Up the Hub 2-7

Installing the Hub on a Table or Shelf

To install the hub on a table or shelf, follow these steps:

Step 1 Be sure the hub is powered off and is not connected to a power source.

Step 2 Locate the adhesive strip with the rubber feet that shipped with the hub.

Step 3 Attach the rubber feet to the round recesses on the bottom corners of the hub.

Step 4 Place the hub on a table or shelf close to an AC power receptacle.

Step 5 Connect one end of the AC power cord to the AC power connector on the hub

and the other end of the cord to a power outlet. If your conﬁguration has a Cisco

RPS, see the RPS documentation.

After power is connected, the hub starts the series of self-tests described in the

“Powering Up the Hub and Running POST” section on page 2-6.

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Pas de commentaire

Giant 1-Feb Manuel d'utilisateur Page 7